Technical Data
Application
They are usually used on:
Machine tools (milling machines – lathes – drills)
Glass processing machines (TRI version)
Surface treatment systems (version in cast iron)*
Filtration systems
Air-conditioning systems
They should usually be installed on a tank, with a capacity in proportion to the flow rate, at about 4 – 5 cm. from the bottom. It is important to check that the maximum level of the liquid in the tank always remains 3 – 4 cm. lower than the flange (see figure).
In cases where the liquid is particularly dirty, the user is recommended to construct the tank in compartments to allow the dirt to deposit before it is stirred up by the pump.
For other usages you are advised to consult our technical office.
